The dimensions shown are for all available IntelliGen® LV dispense system fitting configurations.
The following graph shows highly repeatable dispense characteristics over a span of 200 dispense cycles. The PGMEA chemistry, used in the test, passed through the Impact® filter at a dispense rate of 0.7 mL /sec and a 3 sigma rating of 0.006 mL. The upper and lower limits were 4.050 and 4.010 mL, with an average flow rate of 4.030 mL.
0.01 - 10.0 mL in 0.001 mL increments
0.1 - 3.0 mL/sec in 0.001 mL/sec increments
≤0.02 mL 3 sigma
1 - 100 cP or at higher viscosities when dispense pressure does not exceed 29 psi
Maximum dispense design pressure**
0.20 MPa (29 psi)
Fill rate, filtration rate, vent rate, purge rate
0.1 - 3.0 mL/sec in 0.01 mL/sec increments
Auto-venting or 1-10,000 dispense cycles
Modified PTFE, PTFE, Kalrez®
Insert style, Super Type Pillar® or Flowell™ 60 series
Specifications are dependent on interface module use
Triggers and acknowledgments
See provided documentation.
Indoor use only
Altitude below 2000 m (2187.22 yd)
Ambient temperature 5°C - 40°C (41°F -104°F)
Maximum relative humidity 80% for temperatures up to 31°C (88°F) decreasing linearly to 50% relative humidity at 40°C (104°F)
Mains supply fluctuations from 22 - 26 VDC
Transient overvoltages of overvoltage category II
Pollution degree 2
*Depends on tool configuration. Contact applications support for detailed window of operation. **Maximum pressure is a limit on the Window of Operation. Actual volumes and rates may be restricted to comply with the pressure limits for a given viscosity, tubing diameter, tubing length and tubing height.