i-Tray™ Designer

Invalid selection for Tray Series. Please try again.

Invalid selection for Material. Please try again.
  •  
    View Advanced Options Hide Advanced Options
    Draft, Corner Relief, Through Holes, Cross Slots, Pocket Surface, Pocket Array, Underside Detail, Stacking Option
    • Draft angle must be between 7 and 45 degrees, inclusive.
      Whole number between 7° and 45°
      Chamfer Height must be at least {0}" ({1} mm) if Chamfer Draft is non-zero.
      (Optional)
      Chamfer Angle is required if Chamfer Height is non-zero.
      (Optional)
      Through Hole Size, X1 is required to be non-zero if adding through holes.
      Through Hole Size, Y1 is required to be non-zero if adding through holes.
      Either Cross Slot X Width or Y Width must be non-zero if using Break through Cross Slots or the Cross Slot Depth is non-zero.
      Enter 0 to use pocket Z (depth)
      Break through Cross Slots are not supported for this tray series.
      Invalid selection for Pocket Surface. Please try again.
      Pocket Count in the 'X' direction is required to be non-zero when specifying a custom pocket array.
      Pocket Count in the 'Y' direction is required to be non-zero when specifying a custom pocket array.
      (Optional)
      (Optional)
      (Optional)
      (Optional)
      Invalid selection for Underside Detail. Please try again.

      Stacking option available on 4" trays only. When the tray on tray stacking option is chosen, Entegris will design a backside (force) that will have ribs that sufficiently covers the pocket below in a tray on tray stack.


Reset Properties